348
DP-8032/8025
2008Ver.1.2
@command
delete
@end
This command can also be inserted before the @begin to @end block, to erase the entire Auto Dialler data
first, then reprogram it with new data.
This method will also prevent the "Overwrite Warning Message" that is sent back from your machine, when
the current Auto Dialler station is overwritten.
To erase the entire Auto Dialler data, type the following command in the "Subject" line of your email:
#set abbr(password)# : where the "password" is the Remote Password programmed in your
machine’s User Parameters.
Retrieve, and backup the existing data onto your PC first by following the
procedures for Retrieving, and Editing on the previous pages.
To Next Page
Loading...
