Network Firmware Update Tool (LAN)
Page 8
4.
Enter the device location on the network by using
either Manual Input or Device Address List
methods.
Manual Input Tab
Device Name: Type the name of the device you
are updating (i.e. DP-3010)
IP Address: Type the IP Address of the device
you are updating (this information can generally
be located through the Key Operator or Service
Modes)
Password: Enter the device password
Note: If the default password is used on the
device there is no need to enter it in this box
When compete select the [ >> ] button to add the
destination to the list.
Device Address List Tab
Locate and select the device you would like to
update on the Device Address List.
Select the [ >> ] button to add the destination to
the list.
Note: Multiple destinations can be added to
update more than one device.
Click [OK].
5.
Confirm the device information and
destination(s).
Click [Next>].
To Next Page
Loading...
