Panasonic DP-8032 - Page 45

45
DP-8032/8025
2008Ver. 1.2
(10) Disconnect 4 Harnesses on the PNL1 PC Board
(CN223, CN225, CN229 and CN230).
(11) Remove 4 Screws (F10).
(12) Remove the PNL1 PC Board (1908).
(13) Remove 7 Screws (F10).
(14) Disconnect the Harness on the PNL2 PC Board
(CN251).
(15) Remove the PNL2 PC Board (123).
Note:
After reassembling the Control PNL2 PC Board, make
sure that the Battery Holder is reinstalled.
(16) Disconnect the Harness on the INV PC Board (CN2).
(17) Remove 2 Screws (P5).
(18) Remove the INV PC Board (129) and the Sheet.