51
DP-8032/8025
2008Ver. 1.2
(39) Remove 2 Screws (36).
(40) Remove the Scanning Motor (201).
(41) Disconnect the Harness on the SC PC Board
(CN106).
(42) Release 2 Latch Clips and remove the Ferrite Core.
(43) Remove 3 Red Screws (D24).
(44) Remove the CCD Assembly (207).
Note:
When reinstalling the CCD Assembly, align the hole
with the Red Mark on the CCD Assembly with the
hole on the Scanner Base Frame as illustrated and
secure it with 3 Red Screws.
To Next Page
Loading...
