Panasonic DP-C405 - Page 331

331
DP-C405/C305/C265
FEB 2008Ver. 1.1
E3-28 Developer
Motor 1
Rotation (Y/M/
C)
1. The rotation of the
Developer Motor 1
(Y/M/C) is not
being detected
within a
predetermined
time.
2. Developer Motor 1
(Y/M/C) keeps
rotating after a
predetermined time
has lapsed.
Developer
Motor
1. Check the Motor connector.
2. Motor is defective.
3. Check the EC PCB connector.
4. EC PCB is defective.
5. Y/M/C Drive Mechanism is defective.
6. Y/M/C Developer Unit is defective.
E3-29 Developer
Motor 2
Rotation (BK)
1. The rotation of the
Developer Motor 2
(BK) is not being
detected within a
predetermined
time.
2. Developer Motor 2
(BK) keeps rotating
after a
predetermined time
has lapsed.
Developer
Motor
1. Check the Motor connector.
2. Motor is defective.
3. Check the EC PCB connector.
4. EC PCB is defective.
5. BK Drive Mechanism is defective.
6. BK Developer Unit is defective.
E3-30 Feed Motor
Rotation
1. The rotation of the
Feed Motor is not
being detected
within a
predetermined
time.
2. Feed Motor keeps
rotating after a
predetermined time
has lapsed.
Feed Motor 1. Check the Motor connector.
2. Motor is defective.
3. Check the EC PCB connector.
4. EC PCB is defective.
5. Paper Feed Mechanism is defective.
6. Paper Feed, Sheet Bypass or Paper Exit
Unit is defective.
E3-31 Intermediate
Transfer Belt
Motor Rotation
1. The rotation of the
IT Belt Motor is not
being detected
within a
predetermined
time.
2. IT Belt Motor keeps
rotating after a
predetermined time
has lapsed.
IT Belt
Motor
1. Check the Motor connector.
2. Motor is defective.
3. Check the EC PCB connector.
4. EC PCB is defective.
5. Intermediate Transfer Belt Drive
Mechanism is defective.
6. Intermediate Transfer Belt or Toner Waste
Transfer Unit is defective.
E3: Development System Error Codes
Code Function Contents Section Check Points