page 75 or feature #382 on page 75) and the
media type (feature #383 on page 75, feature
#384 on page 76 or feature #385 on
page 76) match. If either is changed, this
setting will be changed accordingly.
2. MSETN
To change the number of copies to print (“COPIES”)
You can also change the default setting (feature #660 on
page 91).
1. Enter the number of copies (up to 99).
2. MSETN
To change the orientation (“ORIENTATION”)
You can change the print orientation.
You can also change the default setting (feature #661 on
page 91).
1. Press MCN or MDN repeatedly to select the desired
setting.
– “PORTRAIT”: For portrait orientation.
– “LANDSCAPE”: For landscape orientation.
2. MSETN
To select the page layout (“N in 1 TYPE”)
You can save paper by printing 2, 4 or 8 pages onto 1
page. The documents’ size will be reduced to fit the
recording paper.
You can also change the default setting (feature #662 on
page 91).
1. Press MCN or MDN repeatedly to select the desired
setting.
– “OFF”: Deactivates this feature.
– “2 in 1”: 2 pages will be printed onto 1 page.
– “4 in 1”: 4 pages will be printed onto 1 page.
– “8 in 1”: 8 pages will be printed onto 1 page.
2. MSETN
To select a page border for N in 1 (“Nin1 PAGE
BORDER”)
You can select whether or not to print a line between the
pages in N in 1 printing.
You can also change the default setting (feature #663 on
page 91).
1. Press MCN or MDN repeatedly to select the desired
setting.
– “NONE”: For printing without a line.
– “SOLID LINE”: For printing with a line.
2. MSETN
To select duplex print (“DUPLEX”)
You can select the type of binding.
You can also change the default setting (feature #664 on
page 91).
1. Press MCN or MDN repeatedly to select the desired
setting.
– “OFF”: Deactivates this feature.
–
“LONG EDGE”: For long edge binding.
– “SHORT EDGE”: For short edge binding.
2. MSETN
To select continuous print (“CONTINUOUS PRINT”)
You can select whether documents in different file
formats are printed onto 1 page in layout printing or
duplex printing.
You can also change the default setting (feature #665 on
page 91).
1. Press MCN or MDN repeatedly to select the desired
setting.
– “DISABLED”: Only the same file formats can be
printed.
– “ENABLED”: Different file formats can be printed.
2. MSETN
41
5. Printer
To Next Page
Loading...
