For your safety
Laser radiation
CLASS 1 LASER PRODUCT
R The printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
Laser diode properties
Laser output : Max. 10 mW
Wavelength : 760 nm - 800 nm
Emission duration : Continuous
LED light
CLASS 1 LED PRODUCT
R When using the unit, do not look directly at the
CIS’s LED light. Direct eye exposure can cause
eye damage.
CIS’s LED light properties
LED radiation output : Max. 1 mW
Wavelength :
Red : 630 nm typical
Green : 520 nm typical
Blue : 465 nm typical
Emission duration : Continuous
Recording paper exit rollers and fuser unit
R
During or immediately after printing, near the
recording paper exit roller shaft (A) and fuser unit
(B) gets hot. This is normal. Do not touch it.
Note:
R The area near the rear cover (C) may also get warm.
This is normal.
For best performance
Toner cartridge and drum cartridge
R When replacing the toner cartridge or drum cartridge,
do not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
R For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
7
Important Information
To Next Page
Loading...
Need help?
General
