40 to +70C
Ambient humidity 10 to 95%RH (at25C non-condensing)
Storage humidity 10 to 95%RH (at25C non-condensing)
Breakdown voltage
Note1) Note2)
Between input terminal and output terminal
2300 V AC for 1 min.
Between transistor output terminals and relay output
terminals
Between input terminals and power supply/earth
terminals
Between relay output terminals and power
supply/earth terminals
Between transistor output terminals and power
supply/earth terminals
Between power supply terminal and earth terminal 1500 V AC for 1 min.
Between Input terminal and transistor output terminal 500 V AC for 1 min.
Insulation resistance
Note1)
Between input terminal and output terminal
100 M or more
(500 V DC
measured with a
megohm-meter)
Between transistor output terminals and relay output
terminals
Between input terminals and power supply/earth
terminals
Between output terminals and power supply/earth
terminals
Between power supply terminal and earth terminal
Vibration resistance
5 to 8.4 Hz, single amplitude of 3.5 mm, 1 cycle/min
8.4 to 150 Hz, constant acceleration of 9.8 m/s
2
, 1 cycle/min,
10 min on 3 axes
Shock resistance Shock of 147 m/s
2
, 4 times on 3 axes
Noise immunity
1500 Vp-p with pulse widths 50 ns and 1µs (based on in-house
measurements) (AC power supply terminal)
Operation condition Free from corrosive gases and excessive dust
Overvoltage category Category II
Pollution level Pollution level 2
Weight
L14: Approx. 280 g, L30: Approx. 450 g, L40: Approx. 530 g,
L60: Approx. 730 g
Note1)The tool port is not isolated from the internal digital circuit.
Note2) Cutoff current: 5 mA (Factory default setting)
To Next Page
Loading...
