112
VQT3Y04
p When the LCD monitor gets dirty, wipe it
with a soft cloth, such as eyeglass cleaner.
p In a place with drastic tem perature
changes, condensation may form on the
LCD m onitor. Wipe it with a soft cloth,
such as eyeglass cleaner.
p When t
he unit has becom e very cold, for
exam ple due to storage in a cold area, its
LCD m onitor will be slightly darker than
usual im m ediately after the unit is turned
on. The normal brightness will be restored
w hen the unit’s i
nternal tem perature rises.
When condensation forms on the unit, the
lens will cloud up and the unit may not work
properly. Make every effort to ensure that
condensation does not form. If it does form,
take the actions described below.
C auses of condensation
Condensation takes place when the
am bient tem perature or hum idity is
changed as follow s.
p When this unit is brought inside from the
cold (e.g. a ski slope) to a warm room .
p When this unit is m oved from an
air-conditioned car to outside.
p When a
cold room has been warmed up
quickly.
p When cool wind from an air conditioner is
directly blow n onto this unit.
p After rain show ers.
p When this unit is in a very hum id place
where the air is thick with steam . (e.g. a
heated
sw imming pool)
Helpful hint
If, for exam ple, you have used this unit for
recording on a ski slope and are taking it into
a heated room , place the unit inside a plastic
bag, rem ove as much of the air from inside
the bag as possibl
e, then seal the bag.
Leave the unit for about an hour in the room
so the tem perature of the unit is close to the
am bient tem perature of the room , then use
it.
LCD monitor
Extrem ely high precision technology is
em ployed to produce the LCD M onitor
screen featuring a total of approximately
230,000 dots. The result is more than
99.99% effective dots with a mere 0.01%
of the dots inactive or alw ays lit.
However,
this is not a malfunction and
does not affect the recorded picture.
About condensation
To Next Page
Loading...
