Panasonic HC-V100M - About status indicator during charging; About the SD card

111
VQT3Y04
When the status indicator is flashing at a
particularly fast or slow ra te, the
follow ing should be considered.
Flashing with approx. 4 second period
(off for approx. 2 seconds, on for approx.
2 seconds):
p When the battery is over discharged or the
tem perature of
the battery is too high or
low. It can be charged, but it may take a
few hours to com plete the charging
normally.
p It will flash in approx. 2 second intervals
w hen normal charging resum es. Even in
such cases, it may start fl
ashing in
approx. 4 second intervals until charging
is com pleted depending on the conditions
of use.
Flashing with approx. 0.5 second period
(off for approx. 0.25 second, on for
approx. 0.25 second):
p The battery is not charged. Remove the
battery from the unit, and
try charging
again.
p C heck that the terminals of the unit or
battery are not dirty or covered with a
foreign object, and connect the battery
correctly once again. If a foreign object or
dirt is present, turn
off the unit before
rem oving.
p The battery or environm ent is at an
extrem ely high or low tem perature. Wait
until the tem perature has returned to an
appropriate level and try charging again. If
you are still unable t
o charge, there may
be a fault in the unit, battery or AC
adaptor.
Off:
p C harging has finished.
p If the status indicator stays off despite the
charging being unfinished, there may be a
fault in the unit, battery or
AC adaptor.
Refer to page 109 for details on the
battery.
When disposing of or giving aw ay the SD
card, note that:
p Formatting and deletion of this unit or
com puter only changes the file
m anagem ent information and does not
com pletely delete t
he data in the SD card.
p It is recom m ended that the SD card is
physically destroyed or the SD card is
physically formatted using this unit w hen
disposing of or giving aw ay the SD card.
For the physical format, connect the unit to
the
AC adaptor, set the mode sw itch to
, select [SETUP]  [FO RM AT CARD]
 [YES] from the m enus, and then press
and hold dow n the Optical image
stabilizer/Delete button for approximately
3 seconds on the screen below. W hen the
SD card data deletion scr
een appears,
select [YES], and then follow the on-
screen instructions.
For the physical format, connect the unit to
the AC adaptor, set the mode sw itch to
, select [SETUP]  [FO RM AT
MEDIA]  [SD CARD] from the m enus,
and then press and
hold dow n the Optical
image stabilizer/Delete button for
approximately 3 seconds on the screen
below . W hen the SD card data deletion
screen appears, select [YES], and then
follow the on-screen instructions.
p The custom er is responsible for the
m anagem ent
of the data in the SD card.
About status indicator during
charging
About the SD card