- 141 -
Preparations before using [Remote Ctrl]
Install the smartphone application “Image App” on your smartphone. (l 167)
Operate this unit and the smartphone to set up a direct connection.
Check the [Direct Connection Password] setting in [Wi-Fi Setup]. (l 180)
≥ The default setting for [Direct Connection Password] is [OFF].
Select [ON] as needed, for example when the setting seems necessary for your Wi-Fi
environment.
≥ When [Direct Connection Password] is set to [OFF]
j Proceed to “When [Direct Connection Password] is set to [OFF]” in “Using [Remote Ctrl] with a
direct connection”. (l 142)
≥ When [Direct Connection Password] is set to [ON]
j [Easy Connection (WPS)] (l 174)
j Connecting with QR code (l 175)
j Connecting by entering an SSID and Password (l 175)
When the Wi-Fi connection is complete, refer to “When [Direct Connection Password] is set to
[ON]” in “Using [Remote Ctrl] with a direct connection”. (l 143)
1 Check if the wireless access point is compatible with IEEE802.11b/g/n.
2 Set up a Wi-Fi connection between this unit and the wireless access point.
≥ [Easy Connection (WPS)] (l 170)
≥ Searching for wireless access points to set up a connection (l 171)
≥ Setting up a connection manually (l 172)
3 When the Wi-Fi connection is complete, follow the procedure in “Using
[Remote Ctrl] with a wireless access point connection”. (l 143)
≥ Using [Wi-Fi Setup Wizard], you can also set up a Wi-Fi connection in conjunction with the
smartphone application “Image App”. (l 169)
Setting up a direct Wi-Fi connection between this unit and a
smartphone
Setting up a Wi-Fi connection via a wireless access point
To Next Page
Loading...
