Panasonic HC-W580M - Using [Hom.monitor]

- 150 -
Using [Hom.Monitor]
≥ Perform the home monitoring operation on the smartphone. (l 153)
≥ When the firewall is turned on, the Wi-Fi function may not work correctly. If this occurs, check the
network settings.
≥ Proceed to Step 2 when your Wi-Fi connection has been made via [Set Wireless Access Point] in
[Wi-Fi Setup] (l 170 to 173).
1 Press Wi-Fi button on this unit.
2 Touch [Hom.Monitor] on the Wi-Fi menu screen.
3 Turn off the Wi-Fi setting of the smartphone.
4 Start up the smartphone application “Image App”.
≥ (If the device is Android
TM
)
When a Wi-Fi connection guidance screen is displayed, select [No].
≥ (If the device is iOS)
If a confirmation message for the Wi-Fi setup is displayed, select [Close].
5 Enable the home monitoring setting from the menu of the smartphone
application “Image App”.
≥ Select [ (MENU)] # [Application function] # [Home Monitor], and enable [Use Home
Monitor].
6 Select [Set connect. dest.] of the smartphone.
7 Enter the Device ID and Password displayed on the screen of this unit into
the smartphone.
≥ When the entry is complete, select [OK] (on your Android device) or [Complete] (on your iOS device).
≥ If you want to check the Device ID and Password after performing Step 8, on the screen of this
unit, touch [Setup] # [Home Monitor Connect].
8 Touch [ENTER] on the screen of this unit.
≥ Check that the message “Connecting...” has disappeared from this unit.
9 On the smartphone, select [Start Home Monitor] to start home monitoring.
When using the home monitor function for the first time