- 172 -
6 Touch the wireless access point to connect.
≥ If you touch [Refresh], you can search for wireless access points again.
≥ If you touch and select a wireless access point, all characters will be displayed. In this
case, touch [OK].
≥ When no wireless access points are displayed, refer to “Setting up a connection manually”.
(l 172)
≥ If an Encryption key (Password) is not set, the connection is complete and a message is
displayed. Touch [EXIT], and exit [Set Wireless Access Point].
7 (When there is an Encryption key (Password))
Enter the Password.
≥ For details on how to enter characters, refer to page 97.
≥ When the entry is complete, touch [Enter].
≥ A message is displayed when the connection is complete. Touch [EXIT], and exit [Set Wireless
Access Point].
≥ When connecting by [Set Manually], confirm the SSID (Identification name), Authentication
method, Encryption type, and Encryption key (Password) of the wireless access point you are
using.
1 Press Wi-Fi button on this unit.
2 Touch [Wi-Fi Setup].
3 Touch [Set Wireless Access Point].
4 Touch the part with no display of a wireless
access point C.
≥ For information on how to delete wireless access points or
change the search order of wireless access points, please
refer to [Set Wireless Access Point] on page 179.
5 Touch [Set Manually].
6 Touch [INPUT], then enter the SSID of the
wireless access point to be connected.
≥ For details on how to enter characters, refer to page 97.
≥ When the entry is complete, touch [Enter].
Confirming that the Wi-Fi connection is complete
j The status indicator of this unit is lit green
j is displayed on the screen
Setting up a connection manually
To Next Page
Loading...
