Panasonic KX-NCP1000 - Flash;Recall;Terminate

Conditions
• Certain buttons are equipped with a light to indicate the status of the corresponding line or feature.
6.1.2 Flash/Recall/Terminate
Description
A proprietary telephone (PT)
user can use the FLASH/RECALL button (Flash/Recall mode or Terminate mode)
or Terminate button (Terminate mode) to disconnect the current call and originate another call without hanging
up.
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the line used last.
For example, if a CO line call is disconnected, the extension user will hear a new dial tone from the same CO
line.
Terminate Mode: Disconnects the line and the extension user hears a dial tone via the preferred CO line.
(® 10.1.3 Line Preference—Outgoing)
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system programming:
– Flash/Recall mode
– Terminate mode
– EFA mode (® 5.1.1 EFA (External Feature Access))
• Terminate Button
Any flexible button can be customized as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same CO line is programmable for each CO line
port.
• This feature generates a Station Message Detail Recording (SMDR) call record (® 16.1.4 SMDR (Station
Message Detail Recording)), restarts the call timer, inserts a pause, and checks the Toll Restriction (TRS)
level (® 17.1.6 TRS (Toll Restriction)) again.
• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the mode
that the FLASH/RECALL button has been set to, in the following situations:
– When a call is made using ARS. (® 1.1.3 ARS (Automatic Route Selection))
– When a CO line call is made with the INTERCOM button.
– When a CO line call is made with an Incoming Call Distribution (ICD) group button.
PC Programming Manual References
3.30 [1-1] Slot—Port Property - LCO Port—
Disconnect Time
3.36 [1-1] Slot—Port Property - T1 Port— Disconnect Time
6.1 [4-1-1] Wired Extension—Extension Settings—Option 7— Flash Mode during CO Conversation
6.5 [4-1-4] Wired Extension—Flexible Button— Type
6.10 [4-2-1] Portable Station—Extension Settings—Option 7— Flash Mode during CO Conversation
6.13 [4-2-3] Portable Station—Flexible Button— Type
6.18 [4-3] DSS Console— Type
PT Programming Manual References
[418] LCOT Disconnect Time
116 Feature Manual Document Version 2013-05
6.1.2 Flash/Recall/Terminate