Panasonic KX-NCP1000 - Ring Tone Pattern Selection

→ Automatic Redial—Repeat Counter
→ Automatic Redial—Redial Call Ring Duration
→ Automatic Redial—Analog CO Mute / Busy Detection Timer
4.9 [2-6-1] Numbering Plan—Main—Features— Redial
4.18 [2-9] System Options—Option 2
→ Redial—Automatic Redial when No Answer (ISDN)
→ Redial—Save Dial After Connection to Redial Memory
→ Redial—Call Log by Redial key
4.18 [2-9] System Options—Option 7
→ Outgoing Call Log—Extension Call
6.1 [4-1-1] Wired Extension—Extension Settings—Option 7— Outgoing Call Log Memory
6.10 [4-2-1] Portable Station—Extension Settings—Option 7— Outgoing Call Log Memory
PT Programming Manual References
[205] Automatic Redial Repeat Times
Feature Manual References
21.1 Capacity of System Resources
Operating Manual References
1.3.59 Redial, Last Number
1.4.1 Call Log, Incoming
15.1.2 Ring Tone Pattern Selection
Description
It is possible to select the type of ring tone pattern that arrives at an extension for each type of incoming call,
etc.
[Ring Tone Patterns]
1 280 ms
Single
Double
Triple
S-Double
* The duration of a ring tone may vary by country/area.
[Ring Tone Pattern Table]
The ring tone pattern
table is categorized into three parts, each containing a specified number of pattern plans.
The ring tone pattern table is categorized as follows:
• Incoming CO Line Calls: each pattern plan can assign a ring tone pattern for each trunk group.
Document Version 2013-05 Feature Manual 303
15.1.2 Ring Tone Pattern Selection