Panasonic KX-NCP1000 - Private Network Features-QSIG-CT (Call Transfer)

13.1.24 Private Network Features—QSIG—CT (Call Transfer)
Description
The PBX transfers the call to a destination extension in another PBX in the QSIG network.
If the same trunk group is used for the incoming call and the transferred call, the following situation will be
possible.
[Example]
PBX-1
QSIG
PBX-2
Dials "2000".
PBX-1
QSIG
PBX-2
Extn. 1000 Extn. 1001 Extn. 2000
Extn. 1000 Extn. 1001 Extn. 2000
Call to 2000
1
Transferred
to 1001
2
3
1
Extension 1000 of PBX-1 dials
extension number "2000", and the call
is sent to extension "2000" of PBX-2
through QSIG network.
2
The call is transferred from extension
2000 to extension "1001
" of PBX-1.
3
The call between PBX-1 and PBX-2 is
released, and the call is connected
directly to the transfer destination of
extension 2000.
Conditions
• This feature can be enabled or disabled on an ISDN
(QSIG) port basis.
• Call Transfer with Announcement and Call Transfer without Announcement is possible (® 3.1.11 Call
Transfer).
PC Programming Manual References
3.33 [1-1] Slot—Port Property - PRI Port—Supplementary Service— COLP, CLIR, COLR, CNIP, CONP,
CNIR, CONR, CF (Rerouting), CT, CCBS, E911
3.38 [1-1] Slot—Card Property - IP Gateway (KX-TDE series only)— QSIG-CT
3.48 [1-3] Option— New Card Installation—ISDN Standard Mode for PRI23 Card
278 Feature Manual Document Version 2013-05
13.1.24 Private Network Features—QSIG—CT (Call Transfer)