4.1 D
4.1.1 Data Line Security
Description
Once Data Line Security
is set on an extension, communication between the extension and the other party is
protected from signals such as Call Waiting, Hold Recall and Executive Busy Override. Extensions which have
devices connected to them such as modems or fax machines may set this feature to maintain secure data
transmission, by blocking tones or other interruptions during communication.
PC Programming Manual References
4.9 [2-6-1] Numbering Plan—Main—Features—
Data Line Security Set / Cancel
6.1 [4-1-1] Wired Extension—Extension Settings—Option 2— Data Mode
Operating Manual References
1.3.18 Data Line Security
4.1.2 DHCP (Dynamic Host Configuration Protocol) Assignment
Description
It is possible to assign this PBX as a DHCP client, allowing IP addresses to be received from a DHCP server
over a LAN.
Conditions
• It is possible to enable this feature through system programming.
Notice
It is important to set your DHCP server to not change the IP addresses of the MPR and DSP cards once
IP
telephones
are
registered
to the PBX. The IP telephones will not operate properly if these IP addresses
are changed.
PC Programming Manual References
3.4 [1-1] Slot—Card Property - IPCMPR (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IPCEMPR
(for KX-TDE600)—LAN Setting
→
DHCP Client
→ IP Address for IPCMPR Card (for KX-NCP500/KX-NCP1000/KX-TDE100/KX-TDE200)/IP Address
for IPCEMPR Card (for KX-TDE600)
→ IP Address for VoIP-DSP
76 Feature Manual Document Version 2013-05
4.1.2 DHCP (Dynamic Host Configuration Protocol) Assignment
To Next Page
Loading...
