Installation Manual References
KX-NCP500/KX-NCP1000
5.1.5 Troubleshooting by Error Log
KX-TDE100/KX-TDE200
5.1.5 Troubleshooting by Error Log
KX-TDE600
5.1.5 Troubleshooting by Error Log
PC Programming Manual References
13.4 [11-4-1] SNMP—System Setting
13.5 [11-4-2] SNMP—Manager
Feature Manual References
10.1.4 Local Alarm Information
16.1.6 Special Carrier Access Code
Description
If the PBX has access to multiple telephone companies, a Special Carrier Access code assigned through
system programming is required every time a CO line call is made without using ARS.
A pause of a preprogrammed length will be automatically inserted between the user
-dialed Special Carrier
Access code and the subsequent digits. (®
13.1.4 Pause Insertion)
Conditions
• TRS
Toll Restriction (TRS) checks only the dialed telephone number excluding the Special Carrier Access code.
(® 17.1.6 TRS (Toll Restriction))
• ARS
A pause is not automatically inserted between the user-dialed access code and the subsequent digits when
ARS mode is enabled. (® 1.1.3 ARS (Automatic Route Selection))
• If this PBX is installed behind an existing host PBX:
A Special Carrier Access code and a Host PBX Access code should be assigned separately—these codes
cannot be assigned together as one code. (® 8.1.5 Host PBX Access Code (Access Code to the
Telephone Company from a Host PBX))
PC Programming Manual References
9.3 [7-3] Special Carrier
PT Programming Manual References
[303] Special Carrier Access Code
Document Version 2013-05 Feature Manual 321
16.1.6 Special Carrier Access Code
To Next Page
Loading...
