Panasonic KX-NCP1000 - Page 224

Method Description
Required
Hardware
On-site modem The modem is connected to the Serial Interface (RS-232C port)
and also to either an extension port which is assigned as the
DIL/DID destination, or to a CO line directly. AT commands can
be sent to the modem automatically when it is connected to the
Serial Interface (RS-232C port) and can be programmed
beforehand, through system programming, to initialize the
modem. AT commands can also be sent manually in the PT
system programming mode.
User-supplied
modem
Conditions
• Only one system programming
session is permitted at a time. Access will be denied when a second party
tries to perform system programming, including system programming via a PT.
• Programmer Code and Password for System Programming
To access system programming, a programmer code and its password must be entered. For more details,
see Section 13.1.3 Password Security.
• Remote Programming Limitation
It is possible to disable remote access through system programming. Disabling this feature will also disable
the ability to perform on-site programming via modem.
• If an extension user sets Walking Extension at the same time that the extension’s data is being programmed
through PC programming, the data may not be transferred properly. (® 20.1.2 Walking Extension)
Installation Manual References
KX-NCP500/KX-NCP1000
3.3.1 IPCMPR Card
3.3.3 RMT Card (KX-TDA0196)
4.1 Overview
4.2 PC Connection
4.3 Installation of the Maintenance Console
KX-TDE100/KX-TDE200
3.3.1 IPCMPR Card
3.3.4 RMT Card (KX-TDA0196)
4.1 Overview
4.2.1 PC Connection
4.3 Installation of the Maintenance Console
KX-TDE600
3.3.1 IPCEMPR Card
3.3.4 RMT Card (KX-TDA0196)
4.1 Overview
4.2 PC Connection
4.3 Installation of the Maintenance Console
PC Programming Manual References
13.1 [11-1] Main
→RS-232C—
External Modem Command—Automatic Initialization
→RS-232C— External Modem Command—Manual Initialization 1–Manual Initialization 5
224 Feature Manual Document Version 2013-05
13.1.6 PC Programming