Panasonic KX-NCP1000 - Page 286

Conditions
[General]
• Some QSIG services are available. (® 13.1.20 PRIVATE NETWORK FEATURES—QSIG)
• Toll Restriction (TRS)
settings apply to calls rerouted to public CO lines. When making a call using System
Speed Dialing, regular TRS settings are applied, even if the TRS Override by System Speed Dialing feature
is enabled. (® 17.1.6 TRS (Toll Restriction))
[Common Extension Numbering for Multiple PBXs]
• The KX-NCS3910, KX-NCS4910 or KX-NCS4950 (Activation Key for Software Upgrade to Enhanced
Version) is required to use this feature.
• System programming is required to enable this feature.
• If the called extension does not exist at the called PBX, the next PBX in the same gateway group is called
automatically.
• The Routing to Operator setting in system programming must be disabled to use this feature.
• To use this feature, all PBXs in the IP network have to be KX-NCP or KX-TDE series PBXs, version 3.0000
or later.
Installation Manual References
KX-NCP500/KX-NCP1000
3.4.1 Virtual Cards
KX-TDE100/KX-TDE200
3.4.1 Virtual Cards
3.5.5 IP-GW4E Card (KX-TDA0484)
3.5.6 IP-GW16 Card (KX-TDA0490)
KX-TDE600
3.4.1 Virtual Cards
3.7.5 IP-GW4E Card (KX-TDA0484)
3.7.6 IP-GW16 Card (KX-TDA0490)
PC Programming Manual References
3.7 [1-1] Slot—Port Property - Virtual IP Gateway Port
3.39 [1-1] Slot—Port Property - IP-GW Port (KX-TDE series only)
4.10 [2-6-2] Numbering Plan—Quick Dial—
Use quick dial for rerouting to public CO when TIE line does not
work
11.1 [9-1] TIE Table
12.6 [10-4] Miscellaneous— Intercept—Routing to Operator - No Destination (Destination is not
programmed.)
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
13.1.15 PRIVATE NETWORK FEATURES
286 Feature Manual Document Version 2013-05
13.1.26 Private Network Features—VoIP (Voice over Internet Protocol)