Panasonic KX-NCP1000 - Page 81

[Programming Example: DID Table]
Location
1
2
DID
Name
*2
Sales
Judy
DID No.
*1
123-4567
123-2468
Day
Enable
Enable
Lunch
Disable
Disable
Night
Disable
Disable
Break
Enable
Disable
Day
105
102
Lunch
100
100
Break
105
102
CLI Distribution
*3
DID Destination
*4
Night
100
100
*1
® 12.3 [10-3] DID Table—
DID Number
® [451] DID Number
*2
® 12.3 [10-3] DID Table—
DID Name
® [452] DID Name
*3
® 12.3 [10-3] DID Table—
CLI Ring for DID—Day, Lunch, Break, Night
*4
® 12.3 [10-3] DID Table— DID Destination—Day, Lunch, Break, Night
® [453] DID Destination
In this example:
If the DID number is "123-4567":
1. The PBX looks for the DID number in the table and finds it in location 1.
2. The PBX checks the time mode.
In day mode: Calling
Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination,
if assigned. If not assigned, the call is routed to the DID destination, extension 105, and "Sales" is displayed.
In lunch mode: CLI distribution is disabled. The call is routed to the DID destination, extension 100, and
"Sales" is displayed.
Note
Tenant numbers and VM trunk group numbers (not shown here) can also be programmed in the DID
Table.
The tenant number
programmed here is used only to determine the Time Table used by each DID number;
selecting tenant 3 means the DID number will use Time Table 3, for example. The VM trunk group number
set here is used to determine the Incoming Call Service and greeting message used by the Voice
Processing System (VPS) during the current time mode. (® 19.1.4 Voice Mail DPT (Digital) Integration)
Conditions
• To use this feature, DID must be assigned as the distribution method for the desired CO line port.
PC Programming Manual References
4.5 [2-3] Timers & Counters—Miscellaneous—
Incoming Call Inter-digit Timer—DID
12.2 [10-2] DIL Table & Port Settings—DID/TIE
→ Distribution Method
→ DID/TIE—Remove Digit
→ DID/TIE—Additional Dial
12.3 [10-3] DID Table
PT Programming Manual References
[451] DID Number
[452] DID Name
[453] DID Destination
Document Version 2013-05 Feature Manual 81
4.1.6 DID (Direct Inward Dialing)