Panasonic KX-NS500 - Page 228

For standard connection
# PCC Standard Format File # DO NOT CHANGE THIS LINE!
### Management Server Settings #######
ACS_URL="http://xxx.xxx.xxx.xxx:yyy/cwmp/cwmpAction.cgi"
For secure connection
# PCC Standard Format File # DO NOT CHANGE THIS LINE!
### Management Server Settings #######
ACS_URL="http://xxx.xxx.xxx.xxx:yyy/cwmp/cwmpAction.cgi"
CFG_INT_CERTIFICATE_PATH=http://xxx.xxx.xxx.xxx:zzz/utdownload/KX-NS500
Notice
• For "xxx.xxx.xxx.xxx:yyy"
, enter the IP address and port number of the network router which is
in a same LAN with the PBX.
The router accessed by the SIP phone must have static NAT/NAPT settings enabled so that
the packets sent to xxx.xxx.xxx.xxx:yyy to be transferred to the PBX. For details, refer to
"Connection via Internet" in "5.2 PC Connection" and "Internet Connection (TLS
Connection):" in "5.3 Starting Web Maintenance Console".
• Configuration files must end with an empty line.
b. Save the text file as "UT_ACS.cfg".
When the SIP Phones are in a different segments of the same LAN
a. Log in to the Web Maintenance Console of the site where the SIP phones will be registered.
b. Click Utility ® File ® File Transfer PBX to PC.
c. Select the config file (UT_ACS_xxyyyy.cfg), and then download it to your PC.
For more details about downloading files from a PBX to a PC, refer to "7.2.2 Utility—File—File Transfer
PBX to PC" in the PC Programming Manual.
Note
xx: Site ID (2 digits)
yyyy: Site name
*1
(Up to 32 characters
*2
)
*1
Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?,
", <, >, |
(vertical bar), &, +
*2
In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
When the SIP Phones are in a different LAN (Remote site installation)
a. Log in to the Web Maintenance Console of the site where the SIP phones will be registered.
b. Click Utility ® File ® File Transfer PBX to PC.
c. Select the config file (UT_ACS_HTTPS_xxyyyy.cfg), and then download it to your PC.
Note
• xx: Site ID (2 digits)
yyyy: Site name
*1
(Up to 32 characters
*2
)
*1
Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?, ", <, >, |
(vertical bar), &, +
*2
In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
• When SIP phones use the internet to communicate with the PBX, the PBX uses the HTTPS
protocol for security.
228 Installation Manual
5.7.1 Assigning IP Addressing Information