For Non-KX-UT Series SIP Phones (including P-SIP)
After connecting non-KX-UT series SIP phones to the PBX over a network, register those IP terminals to the
PBX manually.
Follow the procedure below for registration.
1.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. Place the mouse cursor over the Virtual Slot, and
in the menu that appears, click Select Shelf.
c. Move
the
mouse pointer over the V-SIPEXT32 card
(Virtual 32-Channel SIP Extension Card).
A menu will be shown under the mouse pointer.
d. Click Port Property.
2. Assign extension numbers to the SIP extensions.
• If the
Automatic Extension Number Set for Extension
Card feature is enabled, the extension numbers of
SIP extension are automatically assigned. To
programme this feature, refer to "9.36 PBX
Configuration—[1-3] Configuration—Option—
New Card Installation—Automatic Extension
Number Set for Extension Card
" in the PC
Programming Manual.
• If not, enter the extension number for each SIP
extension manually.
254 Installation Manual
5.8.1 Registering IP Telephones
To Next Page
Loading...
