Panasonic KX-TC1891B - Page 91

General
Problem
Cause and Remedy
The unit does not work
• Check the settings (p 13-20)
•Charge the battery fully (p 16)
•Clean the charge contacts and charge
again (p 17)
• Install the battery properly (p 16, 86)
• Place the handset on the base unit and
unplug the AC adaptor to reset Plug in,
and try again
You cannot program items,
such as the dialing mode
• Programming is not possible while the
unit is in the talk or speakerphone
mode, when viewing the Caller
List/directory list, or while the answering
system is in use
• Do not pause for over 60 seconds while
programming
• Move closer to the base unit
Previously programmed
information is erased
• If a power failure occurs, programmed
information may be erased Reprogram
if necessary
“Recharge battery” is
displayed, “ f ■ 1” flashes or
the unit beeps intermittently
•Charge the battery fully (p 16)
You charged the battery
fully, but “Recharge
battery” is still displayed
and/or" ( ■ 1 ” continues to
flash
•Clean the charge contacts and charge
again (p 17)
• Install a new battery (p 86)
The IN USE/CHARGE
indicator light does not go
out while charging
•This is normal
If you cannot solve your
problem
•Call our customer call center at
1-800-211-PAN A(7262)
• Panasonic’s e-mail address for
customer inquiries
consumerproducts® Panasonic com
for customers in the USA or Puerto Rico
ONLY
91