Panasonic KX-TC1891B - Page 90

+ Before Requesting Help
Problem
Cause and Remedy
You cannot listen to the
recorded messages
•Make sure that the base unit is in the
standby mode (p 17)
“Message full" IS
displayed and the ANSWER
ON indicator flashes rapidly,
and no new messages are
recorded
• Memory is full Erase some, or all, of
the messages (p 73)
You cannot operate the
answering system at the
base unit
•The handset user is operating the
answering system Wait until the
IN USE/CHARGE indicator light goes
out
You cannot operate the
answering system from a
touch tone phone
• Make sure you enter the correct remote
code
•The answering system may not respond
if the tones are too short to activate the
unit Press each button firmly
•The answering system is off Turn it on
(P 80)
You cannot operate the
answering system with the
handset
•Someone is operating the answering
system
•You are too far from the base unit
Move closer to the base unit
•The unit is recording a message
To answer the call, press the line button
whose status icon is displayed
While recording a greeting
message, the unit starts to
ring and stops recording
•To answer the call, press
[DIGITAL SP-PHONE], (TALK) or the
relevant line button Start again from the
beginning after hanging up
During playback, the unit
starts to ring and stops
playback
•To answer the call, press
(DIGITAL SP-PHONE), (TALK) or the
relevant button To resume playback,
press (NEW MESSAGE) after hanqinq
up
90