Panasonic KX-TCD705RUM - Page 56

Address Default Name Type Description
0F12 64 RingTermToU100 D Ring terminate time-out period. This is the max time that
must elapse between two ring-voltage bursts before the
new ring-voltage is registered as a new incoming call.
Unit: 100 ms. defaults to approx 10 sec.
0F13 08 RingPatternToU100 D Ring pattern timeout. Max. silence period during distinctive
ringing. As long as the silence period does not exceed this
period of time the ring is still considered and counted as
one single ring.
Unit : 100 ms. Defaults to 800 ms
0F14 FF AgcUpdateTime Line AGC update time. The period of time between each
line AGC update. If FFh, line-AGC is disabled. If used
recommended value is 64h (1 sec).
Unit : 10ms, min/max: 10/FF, Defaults to disabled.
0F15 0A LineSeizureTime Line seizure time. The period of time that the PSTN line or
the PSTN HW needs after the hook-switch is activated in
order to be ready. During this period audio is muted. Only
used during outgoing calls or if the special-line seizure
mode is enabled (Cfg:6).
Unit : 10 ms, min/max: 01/FF. Defaults to 100 ms.
0F16 66 InitDialPause D Init-dial-pause. Dial pause inserted after hook-off when
making an outgoing call.
Bit 0..3: init dial pause if PULSE dial-mode. If 0fH then
normal dial-pause is used.
Bit 4..7: init dial pause if DTMF dial-mode. if 0fH then
normal dial-pause is used.
Unit : 500 ms, min/max: 00/0F. Defaults to 3 sec and 3 sec.
0F17..1BB FF..FF Reserved[5] D
14.3.7. Clip configration
Address Default Name Type Description
0F37.. 38 3D 00 Parse.Configuration D Clip parse set configuration
Bit
0: Etsi: 1=enable 0=disable
1: ForwardNumber: 1=enable 0=disable
2: Danish: 1=enable 0=disable
3: Dutch: 1=enable 0=disable
4: Canadian: 1=enable 0=disable
5: Swedish: 1=enable 0=disable
6: UserDefined: 1=enable 0=disable
7: KPN vmwi: 1=enable 0=disable
8: Reserved8
9: Reserved9
10: Reserved10
11: Reserved11
12: Reserved12
13: Reserved13
14: Reserved14
15: Reserved15
14.3.8. BsUiTask
Address Default Name Type Description
0FFD (TCD715 /
TCD735 0xFF
(TCD700 /
TCD705 /
TCD725) 0xF7
Config D BsUiTask configuration
Bits 1=enable 0=disable
0: FlashTime1Enabled.
1: FlashTime2Enabled.
2: FlashTime3Enabled.
3: KeyClicksEnabled:
TCD700 / TCD705 / TCD725: Default disabled TCD715 /
TCD735: Default enabled
4: ARSCarrierMenuEnabled.
5: ARSIntDeletionMenuEnabled.
6: ARSMultipleCarrierMenuEnabled.
7: ARSMultipleAreaCodeMenuEnabled.
0FFE (step6)
0x01
(step5)
0x05
Kamma4BaseModelId A Kamma4 Base Model Identifier:
0x01 = TCD7000
0x02 = TCD7050
0x03 = TCD715
0x04 = TCD725
0x05 = TCD735
56
KX-TCD705RUM / KX-TCD705RUS