1.6 Programming Example
24 Programming Instructions
Programming Structure
Programme
Address
Programming Group Description
[0XX] Manager Programming These programmes may be accessed by the system
manager of the customer to meet frequent changes
requested by the customer.
[1XX] System Programming Entire system programming.
[2XX] Timer Programming Flexible system timer setting.
[3XX] TRS / ARS / TIE Line
Routing Table Programming
Assignment of Toll Restriction, Automatic Route
Selection (ARS) or TIE Line Routing Table.
[4XX] Outside Line / ISDN Line /
TIE Line Programming
Setting of outside line, outside line group, ISDN line
or TIE line values.
[5XX] COS Programming Setting of Class of Service (COS).
[6XX] Extension Programming Setting of extension values.
[7XX] E1 Line Programming Setting of E1 line values.
Sample of Description Explanation
6.
To programme another speed dial number,
press NEXT or PREV, or SELECT and
the desired speed dial number
.
7. Repeat steps 4 through 6.
8. Press END.
(15)
(16)
(17)
(15) Select the best way for you to store another speed
dial number. Pressing the NEXT / PREV allows
you to select the next higher / lower speed dial
number. You can also keep pressing them until the
desired one is displayed. If you press SELECT
and the desired speed dial number, the selected
code is displayed.
Conditions
(18)
(19)
• Each speed dial number has a maximum of 24
digits. The valid characters are 0 through 9,
keys, FLASH, PAUSE, SECRET
and
– (hyphen) buttons.
and #
•
•
•
•
•
•
•
•
Features Guide References
System Speed Dialling
(16) You can continue to programme another entry.
(17) After you have stored all your entries, finish this
programme by pressing END. After pressing END
you can go to any programme address you desire.
You can return to the Initial Message mode any
time by pressing END.
To go to the next larger programme address, do not
press END but press Soft 1 (SKP+) or
VOLUME
or rorate the Jog Dial in the
To go to the next smaller programme address, do
not press END but press SHIFT + Soft 1 (SKP-)
or VOLUME
or rorate the Jog Dial in the
(18) Tells you what you should notice or consider when
doing the programming.
(19) Lists all of the features related to the
programming. These features are described in
the Features Guide.
counter-clockwise direction.
counter-clockwise direction.
To Next Page
Loading...
