2.5 Outside Line Programming
General Programming 199
[431] DID / TIE Incoming Assignment
Description
Assigns a DID / TIE incoming method, immediate or wink, to each DID / TIE format according
to your central office service.
Immediate:
Incoming DID and TIE calls can be received right after the receiving signal
arrives.
Wink:
Incoming DID and TIE calls can be received after the wink signal is transmitted to the
central office (after the receiving signal arrives).
Selection
• DID / TIE format number:
1 through 8,
( =all DID / TIE formats)
•
Immediate / Wink
Default
All DID / TIE formats – Wink
Programming
1.
Enter
431.
Display: 431 SIGNAL IN
2.
Press
NEXT.
Display: Format NO?
3.
Enter a
DID / TIE format number.
To enter DID / TIE format number 1, you can also press
NEXT.
Display example: 1:Wink
4.
Keep pressing
SELECT
until the desired selection is displayed.
5.
Press
STORE.
6.
To programme another DID / TIE format, press
NEXT
or
PREV,
or
SELECT
and the
desired
DID / TIE format number.
7.
Repeat steps 4 through 6.
8.
Press
END.
Conditions
To assign all DID / TIE formats to one selection, press the key in step 3. In this case, the
display shows the contents programed for DID / TIE format number 1.
Features Guide References
Direct Inward Dialling (DID)
To Next Page
Loading...
