2.8 Resource Programming
276 General Programming
[812] DISA DTMF Repeat
Description
Selects whether the system transmits DTMF (Dual Tone Multi-Frequency) signals directly to
the central office (CO) or if the system repeats the DTMF signals to CO in order to adjust gain.
This can be done for an outside-to-outside line call via the Direct Inward System Access
(DISA) feature during dialling and / or during an established call.
Selection
•
Dial
(during dialling) /
Call
(during an established call)
• Mode:
Repeat / Through
Default
Dial and Call – Repeat
Programming
1.
Enter
812.
Display: 812 DISA DTMF
2.
Press
NEXT
to programme the mode during dialling.
To programme the mode during an established call, press
NEXT
again.
Display example: Dial:Repeat
3.
Keep pressing
SELECT
until the desired selection is displayed.
4.
Press
STORE.
5.
Press
NEXT
to programme the mode during an established call.
Display example: Call:Repeat
6.
Keep pressing
SELECT
until the desired selection is displayed.
7.
Press
STORE.
8.
Press
END.
Conditions
None
Features Guide References
Direct Inward System Access (DISA)
To Next Page
Loading...
