4-20 DPT Features
C 4.2 DPT Features
• Setting a new “Call Forwarding” function (All Calls, Busy, Busy/No Answer, etc.)
cancels any other “Call Forwarding” functions and the “Do Not Disturb (DND)”
feature that has been set.
• A floating extension such as MODEM or external pager cannot be programmed as a
forwarding destination.
• Two extensions can set each other as the destination extension. In this case, the
intercom call to the other party while he/she is absent will not be forwarded back to
the original extension.
• Confirmation tone 2 (two beeps) is sent when the previously programmed data is
same as the new data. If it is not, confirmation tone 1 (one beep) is sent. Refer to
“Tone List” in the Appendix (Section 9).
• A flexible button on the KX-T7250 (no FWD/DND button provided) can be assigned
as the FWD/DND button.
• With the KX-T7235 and KX-T7436, you can set or cancel the Call Forwarding features
using the display operation.
Programming References
• Station Programming (Section 2)
Flexible Button Assignment — FWD/DND Button
(System Programming — [005] (Installation Manual) can be used for this assignment.)
Feature References
Call Forwarding — CANCEL
Call Forwarding / Do Not Disturb (4.4/Special Display Features)
Do Not Disturb (DND)
Voice Mail Integration
To Next Page
Loading...
