Panasonic KX-TD816E - Page 509

9-8 Appendix
9 Appendix
DISPLAY EXAMPLE DESCRIPTION
Message Waiting
Night
Not Stored
12:Not Stored
Pref.In:CO-02
Pref.In:NO
Pref.In:Ring
Pref.Out:CO-02
Pref.Out:ICM
Pref.Out:Idle
Pref.Out:No
Save
Terminate
Tone Call
Tone Type-2
TRK GRP-3
VTR-101
Voice Call
2 WAY-REC:1234
2 WAY-TRANS:1234
092-555-2111
Message Waiting (MESSAGE) button is assigned.
Night button is assigned.
No programming is assigned.
Location number is not assigned.
Select “Prime Line (CO Line) Preference — Incoming.”
Select “No Line Preference — Incoming.”
Select “Ring Line Preference — Incoming.”
Select “Prime Line (CO Line) Preference — Outgoing.”
Select “Prime Line (INTERCOM) Preference — Outgoing.”
Select “Idle Line Preference — Outgoing.”
Select “No Line Preference — Outgoing.”
SAVE button is assigned.
Terminate button is assigned.
Select Ring-Calling mode.
Select ringing tone for a CO button or intercom calls.
Group-CO (G-CO) button is assigned.
Voice Mail (VM) Transfer button is assigned.
Select Voice-Calling mode.
Two-Way Record button is assigned.
Two-Way Transfer button is assigned.
One-Touch Dialling button is assigned.
Conditions
• If the displayed characters exceed sixteen digits, “&” is shown at the right-hand edge.
• The duration time display is only shown when you make or receive an outside call.
Count start time for outgoing calls can be programmed as desired.
• When you confirm key programming, be sure to press a button while on-hook. If the
“Full One-Touch Dialling” feature is set, dialling mode will start when pressing PF
(Programmable Feature), DSS, SAVE or REDIAL button.