Panasonic KX-TDA15

2.10 Starting the Hybrid IP-PBX
138 Installation Manual
5. While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared, and the Hybrid IP-PBX as well as all optional service cards (except for the IP-GW4
card) will be initialised to the default values. The DPTs should show the time as 01:00.
The data of the IP-GW4 card will not be initialised.
IMPORTANT
Use only the AC adaptor (Panasonic PSLP1244/Panasonic PSLP1434) and AC cord supplied
with the Hybrid IP-PBX.
LED Indications
Confirming the Trunk Connection
After initialisation, programme the Hybrid IP-PBX and connect trunks to the Hybrid IP-PBX.
To confirm that the trunks are successfully connected, dial [ ] [3] [7] + trunk number (3 digits) on a PT, or
press the PT's S-CO button. You will hear a dial tone if the trunk is available and connected.
Turning off the Hybrid IP-PBX
For safety reasons, make sure to turn off the power switch before unplugging the Hybrid IP-PBX. To unplug,
follow the reverse steps to plug it in.
Indication Colour Description
RUN Green PBX status indication
• OFF: Power Off (includes normal reset)
• ON: Power On and running (on-line)
• Flashing (60 times per minute): Starting up
• Flashing (120 times per minute): Starting up or resetting with:
• the System Initialise Switch in "SYSTEM INITIALIZE"
position
• the SD Memory Card not inserted
ALARM Red Alarm indication
• OFF: Normal
• ON: Alarm (CPU stop, alarm for each optional service card)
• Flashing: Alarm (MPR file error in restarting)