Panasonic Lumix DC-S1 - Adjusting the Flash Output

10. Flash
224
Adjusting the Flash Output
You can adjust the flash output when taking pictures with the flash in TTL
output mode.
1
Select [Flash Adjust.].
≥ ¨ [ ] ¨ [ ] ¨ [Flash
Adjust.]
2
Press 21 to adjust the flash
output and then press or
.
0 It can be adjusted within the range of
[j3 EV] to [i3 EV] in 1/3 EV steps.
0 [ ] is displayed on the recording screen.
0 For information about adjusting the flash output when recording using a
wireless flash, refer to page 228.
0 [Flash Adjust.] cannot be used when the following are set:
– [Firing Mode]: [MANUAL]
– [Wireless]: [ON]
0 You can register functions to Fn buttons:
[] ¨ [ ] ¨ [Fn Button Set] ¨ [Setting in REC mode] ¨ [Flash Adjust.]
(l 279)