Panasonic Palmcoder PV-A16 - Supplying Power (AC Adaptor;Car Battery Cord); AC Adaptor Operation; Car Battery Cord Operation

DC
]
Connect the DC Output on the AC
Adaptor to the DC Input on the
Palmcorder with the DC Power Cable
(supplied).
2
Plug in the AC Adaptor.
• The Power indicator will light up.
hter Socket
]
Connect a PV-C16 Car Battery Cord to
the DO Input ofthe Palmcorder.
2
Start your car engine and then insert the
Car Battery Cord plug into your cigarette
lighter socket.
• There is a fuse located in the lighter plug end
of the cord.
Should fuse replacement be necessary use the
exact current rating (in amps).
Note:
This cord can only be used in vehicles equipped
with DO 12V (negative ground) batteries.
Use only the specified car battery cord.
11