Before you begin...
• Turn ON the Palmcorder.
• Insert a cassette (with tab) to be dubbed.
• To monitor the dubbing, see connections on
page 36.
Your Palmcorder uses advanced Flying
Erase Head technology to produce
exceptionally clean edits.
You can replace existing video segments
with new ones such as a title etc. while
keeping the original audio.
POWER
I
VCR OFF CAMERA
Set the POWER switch to VCR.
PLAY STILL
2
Press PLAY to locate the starting point for
dubbing.
Then press STILL where dubbing is to
begin.
• To preset the stopping point of your
replacement segment, see the Memory-
Stop Editing section below.
o V.DUB
3
Press VIDEO DUB to put the Palmcorder
in Video Dub Pause mode.
STILL
4
Press RECORD/PAUSE or STILL to start
taping a replacement video segment.
Press STOP to stop dubbing.
You can set an automatic Edit stopping
point.
In step 2, locate the point at which you
want the dubbing to stop.
Press DISPLAY twice.
Then press RESET to reset the Counter
Memory to M0000.
Now rewind to the editing start point,
and continue with steps 2-4. The tape will
now stop automatically at "M0000".
35
To Next Page
Loading...
Need help?
General