Top View
0 A.DUB 0 V.DUB COUNTER
REW PLAY _ _ STILL
2
!!!iiii!i_
18
If you stop recording but plan to resume
within 24 hours, you can use the Edit
Standby feature to make a smooth transition
between scenes.
Set the POWER switch to OFF and leave
the cassette in the Palmcorder.
Press RECORD/PAUSE (within 24 hours)
to continue recording.
Note:
If it is longer than 24 hours before you
resume recording, use the manual Easy Edit
feature described below.
Use this feature to prevent gaps on
unwanted overlaps in your recording after
the tape has been removed, then re-inserted,
or has been in the Easy Edit Standby Mode
for more than 24 hours.
POWER
VCR OFF CAMERA
Set the POWER switch to VCR.
Press REWIND to go back a
few seconds on the tape.
PLAY
Then press PLAY to review
the picture on the Viewfinder.
STILL NOWpress STILL at the
(_ location you wish to continue
your recording.
POWER
VCR OFF CAMERA
Set the POWER switch to "CAMERA."
Your Palmcorder will go into the Record/
Pause mode. _
4
Press RECORD/PAUSE to continue
recording.
REW
Press REWIND while in Record/Pause
mode to review the last few seconds of your
recording.
To Next Page
Loading...
Need help?
General