16 - ENGLISH
Within 15°
Within 15°
Within 30°
Within 30°
rCautions when setting the projectors
f Use the adjustable feet only for the oor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f When installing the projector with a method other than the oor installation using the adjustable feet or the
ceiling installation using the ceiling mount bracket, use the four screw holes for ceiling mount (as shown in the
gure) to x the projector.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f Use a torque screwdriver or Allen torque wrench to tighten the xing screws to their speci ed tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M4, tapping depth inside the projector: 10 mm (13/32"), screw tightening torque: 1.25 ± 0.2 N·m)
Adjustable feet
Screw holes for ceiling mount
(M4)
Positions of screw holes for ceiling mount
and adjustable feet
f Do not block the intake and exhaust vents of the projector.
f Avoid heating and cooling air from the air conditioning system directly blow to the intake and exhaust vents of
the projector.
over 500 mm
(19-11/16")
over 1 000 mm
(39-3/8")
over 500 mm (19-11/16")
over 200 mm
(7-7/8")
f Do not install the projector in a con ned space.
When placing the projector in a con ned space, a ventilation and/or air conditioning system is required. Exhaust
heat may accumulate when the ventilation is not enough, triggering the protection circuit of the projector.
f Panasonic takes no responsibility for any damage to the product caused by an inappropriate choice of location
for installing the projector, even if the warranty period of the product has not expired.
Chapter 1 Preparation - Precautions for use
To Next Page
Loading...
