ENGLISH - 23
Note
f The remote control can be used within a distance of about 7 m (22'11-5/8") if pointed directly at the remote control signal receiver. The
remote control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
f You can operate the projector by reecting the remote control signal on the screen. The operating range may differ due to the loss of light
caused by the properties of the screen.
f When the remote control signal receiver is lit with a uorescent light or other strong light source, the projector may become inoperative. Set
the projector as far from the luminous source as possible.
Projector body
4
1
11
1
2
3
1
1
5 9876 10
Front
Rear
Side
Side
Projection direction
WARNING
Keep your hands and other objects away from the exhaust vent.
f Keep your hand and face away.
f Do not insert your nger.
f Keep heat-sensitive articles away.
Heated air from the exhaust vent can cause burns, injury, or deformations.
1 Adjustable feet
Adjust the projection angle.
2 Projection lens
3 Remote control signal receiver (front)
4 Exhaust vent
Connect the supplied power cord.
6 Security slot
This security slot is compatible with the Kensington
security cables.
7 Remote control signal receiver (rear)
8 Security chain hook
Attaches a burglar prevention cable, etc.
9 Rear terminals (x page 25)
10 Speaker
11 Intake vent / Air lter cover (x page 113)
The air lter unit is inside.
Attention
f Do not block the intake and exhaust vents of the projector.
Chapter 1 Preparation - About your projector
To Next Page
Loading...
