Panasonic PT-TX440

22 - ENGLISH
About your projector
Remote control
1
2
3
4
5
6
7
8
9
10
14
13
12
15
16
17
18
11
1 Power <v/b> button (v standby / b power on)
Sets the projector to the state where the projector is
switched off (standby mode). Also starts projection when
the power is switched off (standby mode).
2 Input selection buttons (<COMPUTER 1> /
<COMPUTER 2> / <HDMI 1/2> / <VIDEO> / <MEMORY
VIEWER/NETWORK>)
Switches the input signal to project. (x page 40)
3 <MENU> button / <RETURN> button / asqw buttons
/ <ENTER> button
Used to navigate through the menu screen. (x page 49)
The asqw buttons are also used to select characters in
the menu screen.
4 <FREEZE> button
Pauses the projected image and mute the audio
temporarily. (x page 44)
5 Number (<1> - <6>) buttons
Used for entering the ID number in a multiple projector
environment.
6 Remote control signal transmitter
7 <AUTO SETUP> button
Used to perform automatic adjustment while projecting the
image (x page 44).
8 <MUTE> button
Used to mute the audio. (x page 43)
9 <AV MUTE> button
Used to turn off the audio and video temporarily.
(x page 43)
10 <DAYLIGHT VIEW> button
Used to correct the image when the projector is used in a
bright surroundings. ( x pages 46, 55)
11 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 50)
12 <ID SET> button
Sets the ID number of the remote control in a multi-
projector environment. (x page 26)
13 <D.ZOOM+> button / <D.ZOOM-> button
Zoom in and out the images. (x page 45)
14 <VOL +> button / <VOL -> button
Adjusts the volume of the built-in speaker or audio output.
(x page 43)
15 <FUNCTION> button
Species a shortcut button for a frequently used
operation.(x page 46)
16 <ID ALL> button
Used to simultaneously control all the projectors with
one remote control when using multiple projectors.
(x page 26)
17 <P-TIMER> button
Operates the P-timer function. (x page 45)
18 <SCREEN ADJ> button
Corrects the distortion of the projected image.
(x page 44)
Attention
f Do not drop the remote control.
f Avoid contact with liquids.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on
the back of the remote control unit (see the right picture).
g Do not use a new battery together with an old battery.
g Do not use unspecied batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this rst!".
1. 请勿把旧电池和新电池一起使用。
2. 请勿使用不合规格的电池。
3. 确保电池安装正确。
原产地：中国
1.Do not use old battery with new one.
2.Do not use batteries other than the
type specified.
3.Be sure the batteries are inserted properly.
Made in China
Caution label at the back of the remote control
Chapter 1 Preparation - About your projector