82 - ENGLISH
[NETWORK] menu
On the menu screen, select [NETWORK] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (x page 49) for the operation of the menu screen.
Note
f The on-screen menu (menu screen) of the projector has not the network setting about the wireless LAN. When the wireless module (Model
No.: AJ-WM50 / ET-WML100) of the optional accessories is inserted to the projector, please set the wireless LAN by accessing the projector
via a computer. For details, please refer to “Web control function” → “[Network config] page” → “Wireless LAN” (x page 101).
[WIRED LAN]
Perform the connection settings to use wired LAN.
1) Press as to select [WIRED LAN].
2) Press the <ENTER> button.
f The [WIRED DETAILED SETUP] screen is displayed.
3) Press as to select an item, and change the setting according to the instructions.
[DHCP]
[OFF]
Set when a DHCP server does not exist in the network to which the projector is
connected and you need to specify the IP address.
[ON]
Set when a DHCP server exists in the network to which the projector is
connected and the IP address is obtained automatically.
[IP ADDRESS]
Enter the IP address when [DHCP] is set to [OFF].
[SUBNET MASK]
Enter the subnet mask when [DHCP] is set to [OFF].
[DEFAULT GATEWAY]
Enter the default gateway address when [DHCP] is set to [OFF].
[DNS1]
Enter the preferred DNS server address when [DHCP] is set to [OFF].
[DNS2]
Enter the alternate DNS server address when [DHCP] is set to [OFF].
4) Press as to select [STORE], and press the <ENTER> button.
f The confirmation screen screen is displayed.
5) Press as to select [OK], and press the <ENTER> button.
r Default wired LAN settings
f The following settings are set before the projector leaves the factory.
[DHCP]
OFF
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1]/[DNS2]
NONE
Note
f When using a DHCP server, conrm that the DHCP server is running.
f For the setting content of each item, consult your network administrator.
f A wired LAN and wireless LAN cannot be used in the same segment.
[PROJECTOR NAME]
Change the name as desired in such a case as the projector needs to be identied on application software.
1) Press as to select [PROJECTOR NAME].
2) Press the <ENTER> button.
f The [PROJECTOR NAME CHANGE] screen is displayed.
3) Select characters with the asqw buttons and press the <ENTER> button to enter the projector
name.
f Up to eight characters can be input.
f Select [ALL DELETE] to delete all the entered characters, or select [DELETE] to delete a character.
f The <DEFAULT> button on the remote control can also be used to delete a character.
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
