84 - ENGLISH
f The factory default password is blank.
g To continue the use of blank password, proceed to Step 5).
g To set a new password, proceed to Step 3).
3) Press as to select [PASSWORD] under [NEW] to input the new password.
f Up to 32 characters can be input.
f Select [ALL DELETE] to delete all the entered characters, or select [DELETE] to delete a character.
f The <DEFAULT> button on the remote control can also be used to delete a character.
4) Press as to select [PASSWORD CONFIRM] to re-enter the new password for confirmation.
5) Press as to select [STORE], and press the <ENTER> button.
Note
f The [PJLink PASSWORD] menu is disabled if the password of the [ADMINISTRATOR ACCOUNT] has not being set.
f The PJLink password can also be set by accessing from web page. (x page 107).
[NETWORK CONTROL]
Set up the control method of the network.
1) Press as to select [NETWORK CONTROL].
2) Press the <ENTER> button.
f The [NETWORK CONTROL] screen is displayed.
3) Press as to select an item, and press qw to change the setting.
[WEB CONTROL]
Set to [ON] to control with the web browser.
[PJLink CONTROL]
Set to [ON] to control with the PJLink protocol.
[PJLink NOTIFICATION]
Set to [ON] to use the PJLink notication function.
f The [PJLink NOTIFICATION] screen is displayed when set to [ON] and the <ENTER> button is
pressed. Set the IP address of the computer to notify the status of the projector in [NOTIFIED IP
ADDRESS 1], [NOTIFIED IP ADDRESS 2].
[COMMAND CONTROL]
Set to [ON] to control with the <SERIAL IN> terminal control command format. Refer to “Control
commands via LAN” (x page 123).
[COMMAND PORT]
Set the port number used for command control.
[Crestron Connected(TM)]
Set to [ON] to control with Crestron Connected of Crestron Electronics, Inc.
[AMX D. D.]
Set to [ON] to control with the controller of AMX Corporation.
Setting this function to [ON] enables detection through “AMX Device Discovery”. For details, visit the
website of AMX Corporation.
URL http://www.amx.com/
4) Press as to select [STORE], and press the <ENTER> button.
5) When the confirmation screen is displayed, press as to select [OK], and press the <ENTER>
button.
Note
f The [NETWORK CONTROL] menu is disabled if the password of [ADMINISTRATOR ACCOUNT] has not being set.
[MEMORY VIEWER]
Set the operations of the Memory Viewer function.
Note
f The [MEMORY VIEWER] menu can be operated and set only when MEMORY VEWER input is selected.
f For details on how to use the memory viewer function, please refer to "Projecting with MEMORY VIEWER input" (x page 88).
[SET SLIDE]
Start the slideshow. For details on the slideshow, see "Executing the slide" (x page 89).
[SLIDE TRANSITION EFFECT]
Sets the transition effects when switching the slides playback.
1) Press as to select [SLIDE TRANSITION EFFECT].
Chapter 4 Settings - [NETWORK] menu
To Next Page
Loading...
