76 - ENGLISH
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [BALANCE].
4) Press qw to adjust the level.
Operation Adjustment Range
Press the w button.
Increase the volume of the right channel.
L16 ~ R16
Press the q button.
Increase the volume of the left channel.
Setting the mute status
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [MUTE].
4) Press qw to switch the item.
[OFF]
Outputs the audio.
[ON]
Turns off the volume temporarily.
Setting the audio output during standby
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select [IN STANDBY MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables audio output in the standby mode.
[ON]
Enables audio output in the standby mode. At this time, press the <VOL +> button / <VOL -> button on the
remote control or on the control panel to adjust the volume.
Note
f When [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or [NETWORK] (x page 74), [IN STANDBY MODE] is disabled and
audio cannot be output during standby.
f When the power is switched off at the digital signal input with [IN STANDBY MODE] set to [ON], the audio may be interrupted in the process
of the projector entering the standby mode.
Setting audio input selection
Choose the audio input terminal for each input signal.
1) Press as to select [AUDIO SETTING].
2) Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3) Press as to select one item of [AUDIO IN SELECT].
[COMPUTER1]
Set the audio output when COMPUTER1 input is selected.
[COMPUTER2]
Set the audio output when COMPUTER2 input is selected.
[VIDEO]
Set the audio output when VIDEO input is selected.
[HDMI1]
Set the audio output when HDMI1 input is selected.
[HDMI2]
Set the audio output when HDMI2 input is selected.
[NETWORK]
Set the audio output when NETWORK input is selected.
[MEMORY VIEWER]
Set the audio output when MEMORY VIEWER input is selected.
4) Press qw to switch the item.
f The sub items will switch each time you press the button.
Chapter 4 Settings - [PROJECTOR SETUP] menu
To Next Page
Loading...
