66 - ENGLISH
Note
f When [WARNING MESSAGE] is set to [OFF], the warning message will not be displayed on the projected image even if a warning status
such as “TEMPERATURE WARNING” is detected. The prompting message for lter replacement or lamp unit replacement will not be
displayed either.
[HDMI SIGNAL LEVEL]
Switch the setting when the external equipment is connected to the <HDMI 1 IN> / <HDMI 2 IN> terminal of the
projector and the image is not projected correctly.
1) Press as to select [HDMI SIGNAL LEVEL].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
Sets the signal level automatically.
[64-940]
Select when the HDMI terminal of an external device (such as a blu-ray player) is connected to the <HDMI 1
IN> / <HDMI 2 IN> terminal.
[0-1023]
Select when the DVI terminal output of an external device (such as a computer) is connected to the <HDMI 1
IN> / <HDMI 2 IN> terminal via a conversion cable or similar cable.
Select also when the HDMI terminal output of a computer or other device is connected to the <HDMI 1 IN> /
<HDMI 2 IN> terminal.
Note
f The setting of the [HDMI SIGNAL LEVEL] is common to the <HDMI 1 IN> terminal and <HDMI 2 IN> terminal.
f The optimal setting varies depending on the output setting of the connected external device. Refer to the operation instruction of the
external device regarding the output of the external device.
f The displayed signal level is assumed when the input is 30 bits.
[CLOSED CAPTION SETTING] (Only for NTSC, 480i YC
B
C
R
input)
Set the closed caption.
Selecting the closed caption display
1) Press as to select [CLOSED CAPTION SETTING].
2) Press the <ENTER> button.
f The [CLOSED CAPTION SETTING] screen is displayed.
3) Press as to select [CLOSED CAPTION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Closed captions are not displayed.
[ON]
Closed captions are displayed.
f When [ON] is selected, proceed to Step 5).
5) When the confirmation is displayed, select [OK], and press the <ENTER> button.
Setting the closed caption mode
1) Press as to select [CLOSED CAPTION SETTING].
2) Press the <ENTER> button.
f The [CLOSED CAPTION SETTING] screen is displayed.
3) Press as to select [MODE].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[CC1]
Displays CC1 data.
[CC2]
Displays CC2 data.
Chapter 4 Settings - [DISPLAY OPTION] menu
To Next Page
Loading...
