ENGLISH - 33
Connecting example: Computers
Audio equipment
Computer
Computer
Control computer
Control computer
Computer
USB memory /
Wireless module
(Model No.: AJ-WM50 /
ET-WML100)
Attention
f When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standards
is used, images may be interrupted or may not be projected.
f This projector does not support the VIERA Link (HDMI) or HDMI CEC (Consumer Electronics Control).
f If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
f When the <VARIABLE AUDIO OUT> terminal is connected with cable, the sound will not be output from the built-in speaker.
f Attach the optional wireless module (Model No.: AJ-WM50 / ET-WML100) or USB memory directly to the <USB A (VIEWER/WIRELESS/DC
OUT)> terminal of this projector without using a USB extension cable or USB hub.
f If the video signal from the DVI-D terminal of the external device (such as a computer) is connected to the <HDMI 1 IN> / <HDMI 2 IN>
terminal by using a conversion cable, you need to set the [PROJECTOR SETUP] menu → [AUDIO SETTING] → [AUDIO IN SELECT] to
[AUDIO IN 1] or [AUDIO IN 2] (
x page 75) and input the audio signal to the <AUDIO IN 1> or <AUDIO IN 2> terminal.
Chapter 2 Getting Started - Connecting
To Next Page
Loading...
