Panasonic PT-TX440 - Powering On;Off; Connecting the Power Cord; Power Indicator

ENGLISH - 35
Powering on/off
Connecting the power cord
Make sure that the supplied power cord is securely xed to the <AC IN> terminal of the projector body to prevent it from being
removed easily.
For details of power cord handling, refer to “Read this rst!” (x page 4).
Attaching
1) Check the shapes of the <AC IN> terminal on the back of the projector body and the power cord
connector and insert the connector completely in the correct direction.
x
Removing
1) Confirm that the projector is in standby mode, and remove the power plug from the outlet.
2) Remove the power cord connector from the <AC IN> terminal.
Power indicator
The power indicator <ON(G)/STANDBY(R)> informs you the status of the power. Conrm the status of the power
indicator <ON(G)/STANDBY(R)> before operating the projector.
INPUT
AV MUTE
VOL+
VOL-
Power indicator <ON(G)/STANDBY(R)>
Indicator status Status
Off The power plug is not connected to the outlet.
Red
Lit
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [ECO].
Blinking*
1
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NETWORK].
Blinking*
2
The power is switched off (in standby mode). The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] →
[STANDBY MODE] is set to [NORMAL].
Green
Lit Projecting.
Blinking*
3
The luminous lamp is turned off. The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [POWER
MANAGEMENT] is set to [READY].
Blinking*
4
The projector is preparing to project. The projector will project image after a while.
Orange Lit
The projector is preparing to be switched off.
The power is switched off after a while. (Changes to the standby mode.)
Chapter 3 Basic Operations - Powering on/off