Panasonic PT-TX440

ENGLISH - 53
[PICTURE] menu
On the menu screen, select [PICTURE] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (x page 49) for the operation of the menu screen.
[PICTURE MODE]
You can switch to the desired picture mode suitable for the image source and the environment in which the
projector is used.
1) Press as to select [PICTURE MODE].
2) Press qw or the <ENTER> button.
f The [PICTURE MODE] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[STANDARD]
The picture becomes suitable for moving images in general.
[DYNAMIC]
The light output is maximized for use in bright areas.
[BLACKBOARD]
The picture becomes suitable for projecting on a black board.
[WHITE BOARD]
The picture becomes suitable for projecting on a white board.
[CINEMA]*
1
The picture becomes suitable for movie sources.
[NATURAL]*
2
The picture becomes suitable for use in low-light areas.
*1 Only for the movie-based signals.
*2 Only for the still image signals.
[CONTRAST]
You can adjust the contrast of the colors.
1) Press as to select [CONTRAST].
2) Press qw or the <ENTER> button.
f The [CONTRAST] individual adjustment screen is displayed.
3) Press qw to adjust the level.
Operation Adjustment Adjustment range
Press the w button.
Brightens the screen and makes the color of image deeper.
-32 ~ +32
Press the q button.
Darkens the screen and makes the color of image lighter.
Attention
f Adjust [BRIGHTNESS] rst when you need to adjust [BRIGHTNESS] and [CONTRAST].
[BRIGHTNESS]
You can adjust the dark (black) part of the projected image.
1) Press as to select [BRIGHTNESS].
2) Press qw or the <ENTER> button.
f The [BRIGHTNESS] individual adjustment screen is displayed.
3) Press qw to adjust the level.
Operation Adjustment Adjustment range
Press the w button.
Increases the brightness of the dark (black) parts of the screen.
-32 ~ +32
Press the q button.
Reduces the brightness of the dark (black) parts of the screen.
[COLOR]
(Only for movie-based signal input)
You can adjust the color saturation of the projected image.
Chapter 4 Settings - [PICTURE] menu