Panasonic PT-TX440

56 - ENGLISH
[DIGITAL CINEMA REALITY]
You can increase the vertical resolution and enhance the image quality by performing cinema processing when
the supported signals are input.
1) Press as to select [DIGITAL CINEMA REALITY].
2) Press qw or the <ENTER> button.
f The [DIGITAL CINEMA REALITY] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Performs cinema processing.
[OFF]
Performs no cinema processing.
[NOISE REDUCTION]
(Only for the Video signal of the <VIDEO IN> terminal or the Y/C signal of the <COMPUTER 1 IN> terminal)
You can reduce noises when the input image is degraded and noise is occurring in the image signal.
1) Press as to select [NOISE REDUCTION].
2) Press qw or the <ENTER> button.
f The [NOISE REDUCTION] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables [NOISE REDUCTION].
[ON]
Enables [NOISE REDUCTION].
Attention
f When this is set for an input signal with less noise, the image may look different from what it originally was. In such a case, set it to [OFF].
[TV-SYSTEM]
(Only for the Video signal of the <VIDEO IN> terminal or the Y/C signal of the <COMPUTER 1 IN> terminal)
The projector will automatically detect the input signal, but you can set the color system manually when an
unstable signal is input. Set the color system matching the input signal.
1) Press as to select [TV-SYSTEM].
2) Press qw or the <ENTER> button.
f The [TV-SYSTEM] individual adjustment screen is displayed.
3) Press qw to select the color system.
f The items will switch each time you press the button.
f Select among [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [PAL60] and [SECAM].
f Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL], [PAL-M],
[PAL-N], [SECAM] or [PAL60].)
[RGB/YP
B
P
R
] / [RGB/YC
B
C
R
]
The projector will automatically detect the input signal, but you can set the system format manually when an
unstable signal is input. Set the system format matching the input signal.
1) Press as to select [RGB/YP
B
P
R
] or [RGB/YC
B
C
R
].
2) Press qw or the <ENTER> button.
f The [RGB/YP
B
P
R
] or [RGB/YC
B
C
R
] individual adjustment screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
Chapter 4 Settings - [PICTURE] menu