144
REMOTE CONTROLLER INSTALLATION PROCEDURE
• Remove the remote controller lower case.
(Insert a flat-tipped screw driver or similar 2 to 3
mm into one of the gaps at the bottom of the case,
and then twist the screw driver to open. [Refer to
the illustration on the right.])
Be careful not to damage the lower case.
• Secure the lower case to the wall or outlet box.
(Refer to the illustration on the right for the
embedded and exposed positions for the remote
control cable.)
NOTE
* Do not remove the protective tape which is
affixed to the upper case circuit board.
• If installing the remote controller with the remote
control cable exposed, use nippers to cut a notch
into the upper case. (The feeding-out direction
can be either up or to the left or right)
• Strip the end of the remote control cable which is
to be connected to the remote controller. (Refer to
the illustration on the right)
• Route the remote control cable inside the lower
case in accordance with the intended feeding-out
direction. (Refer to the illustration on the right)
Securely connect the connector CN1. (If it is not
connected, the remote controller will not operate.)
NOTE
* After connecting the connector, do not suspend
the upper case by its own weight, otherwise the
connector cord may break.
Do not suspend the
upper case by its own
weight. (The connector
may break.)
Approx. 7 mm
Approx. 20 mm
Upper case
Lower case
Gaps
Lower
case
4 mm screws
(accessories)
To Next Page
Loading...
