Panasonic S-22KA1E5 - Page 145

145
Connector cord
Lower case
Setting switch
Top feeding-out position
Notches
Upper case
Left feeding-out
position
Remote control
cable
Rear feeding-out
position (when
cable is to be
embedded)
MASTER
SLAVE
Temperature sensor
Ventilation holes
Connector
CN1
Right
feeding-
out
position
Tab
• If controlling using two remote controllers, refer to
the “Control using two remote controllers” under
section “4. Settings.”
• Secure the upper case to the lower case.
(Hook the upper tab of the upper case into the
lower case, and then push the upper case until it
snaps shut onto the lower case tab, while being
careful not to clamp the remote control cable and
the connector cord.)
Upper
case
Lower case
If remote control cable is embedded
1. Embed an outlet box into the wall, and then secure the remote controller base plate to the outlet box with the two
accessory M4 screws. Make sure that the base plate is flat against the wall at this time, with no bending
(looseness)
2. Pass the remote control cable into the box and then install the remote controller.
Medium-sized square outlet bo
x
(obtain locally)
M4 screw
(accessory)
Remote controller
lower case
Connector CN1
Upper tab
Remote controller
upper case
Wall
Terminal block
Remote
control cable
Lowe
r
ta
b