Panasonic VB-44210G - Page 191

Section 700 - Operation Chapter 4. Key Telephone Features
DBS-2.3/9.2-700 DBS Manual - Revised April 2000 4-75
7. Press the
HOLD
key.
To assign System Speed Dial numbers to One-Touch keys:
1. Press the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press the
PROG
key.
3. Press the One-Touch key to be programmed.
4. Press the
AUTO
key.
5. Enter the System Speed Dial Number to be programmed.
6. Press the
HOLD
key.
7. Press the
ON/OFF
key.
The
ON/OFF
LED goes off.
To chain two to five System Speed Dial numbers to a single One-
Touch key:
1. Press the
ON/OFF
key.
• The phone issues intercom dial tone.
• The
ON/OFF
LED lights.
2. Press the
PROG
key.
3. Press the One-Touch key to be programmed.
4. Press the
AUTO
key.
5. Enter the System Speed Dial number for the pooled trunk access code.
[This preprogrammed System Speed Dial must contain a C (
CONF)
followed by 9, 1-6 for pooled trunk access groups 9, 81-86).]
6. If a pause is required, press the
REDIAL
key.
This inserts a pause between the access code and the telephone number.
When
REDIAL
is pressed, an “
R
” displays. If viewed later, a “
P
”
displays.